Flatline Van Co - Sprinter Van Side Steps
Secure footing without the awkward climb
Flatline Van Co. Sprinter Side Steps make it easier to get into a stock-height or lifted van while keeping a high-and-tight profile along the body. Dimpled tread plates add traction, and the steel-tube construction gives the van a clean, purposeful stance.
The driver-side traction step is 33.5 inches long and stops before the rear wheel arch to preserve room for a side ladder. The passenger-side traction step is 53.5 inches long and is designed to work with Flatline Van Co.'s Step Extension.
Construction and compatibility
- Heavy-duty 2 x 2-inch square steel tube and 1.75-inch round steel tube
- Dimpled tread plates in the step hoops
- Bolt-on mounting system with required installation hardware
- Compatible with Flatline Van Co. Apex, Wheel Wrap, and Standard Side Ladders without modification
- Revel configuration mounts to the existing Revel brackets
Fitment
2007+ Mercedes-Benz Sprinter 1500, 2500, 3500, and 3500XD; 144-inch, 170-inch, and 170 EXT wheelbases; low- and high-roof vans. Choose Winnebago Revel for the Revel-specific bracket configuration.
Important: Passenger vans with rear heat or A/C may require modification. These steps are not compatible with the eSprinter. Confirm your chassis, wheelbase, underbody equipment, heater/fuel-line routing, and ladder plans before ordering.
Installation resources
- 144-inch installation guide
- 170-inch installation guide
- Winnebago Revel installation guide
- Passenger-van supplemental guide
California Proposition 65: This product can expose you to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. See P65Warnings.ca.gov.
