Mid City Engineering - OEM 360 Degree Camera On-Demand ODB Programmer | 19-24 Sprinter
Two programming options:
1) Allows OEM 360-degree camera to be turned on at speeds above 10 MPH
2) Use 360 camera without any 10 MPH auto cutoff for full control.
1) Allows OEM 360-degree camera to be turned on at speeds above 10 MPH
2) Use 360 camera without any 10 MPH auto cutoff for full control.
- Plug & play OBD programmer- installs in minutes
- The OEM 360 camera button only activates the 360 degree camera at speeds below 10 MPH. Remove that limitation with this programmer.
Compatible vehicles:
- Sprinter 2019-2024 equipped with OEM 360 degree camera system
Note: this programmer is only compatible with vehicles equipped with the OEM 360 degree camera system (full 360). For vehicles with rear camera only, use the 907RVC-I (click here) and for vehicles with rear camera only and parking sensors, use the 907OBDRPS (click here)
Click here for installation / programming instructions
** This is a single vehicle use programmer. The programmer will not work on multiple vehicles- but the same vehicle can be programmed multiple times, if needed.Compatible Vehicles:
- Sprinter 2019-2024
Note:
- Only compatible with MBUX equipped Sprinters with OEM 360 camera or backup camera only MBUX Sprinters with factory parking sensors.
- This is a single vehicle use programmer. The programmer will not work on multiple vehicles- but the same vehicle can be programmed multiple times, if needed.
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.